RC Drift Car LDRC LD 1898 1/18 Scale with Gyro

• 1 × LDRC LD 1898 GTR RC Drift Car (fully assembled)
• 1 × 2.4 GHz Remote Control
• 1 × 7.4V 500 mAh LiPo Battery
• 1 × USB Charging Cable
• 1 × Set of Drift Tyres
• 1 × Screwdriver
• 1 × Carry Bag
• 1 × User Manual

Note: 2 × AA batteries for the remote are NOT included.

1. Charge the battery — plug the LiPo into the USB cable. Full charge ≈ 2 hours.
2. Install 2 × AA batteries in the remote (not included).
3. Power on the car first, then the remote — always this order so they bind correctly.
4. Wait 3–5 seconds for the gyroscope to calibrate before driving.
5. Start at half-throttle to get a feel for the steering before attempting drifts.

• Never run the battery flat — when the car noticeably slows down, stop and charge. Over-discharging LiPo cells permanently damages them.
• Charge via USB at room temperature — avoid direct sunlight or a hot environment.
• Full charge ≈ 120 minutes.
• Spare batteries are 7.4V 2S LiPo with a JST connector — widely available.

• Use low-friction surfaces — polished tile or smooth concrete gives the longest, cleanest slides.
• Build speed before drifting — do not floor it from a standstill. Build speed, then flick the steering to initiate the slide.
• Counter-steer to hold the slide — once the rear breaks loose, steer opposite to extend the drift.
• Trust the gyroscope — it is tuned for stability. Fighting it shortens your drifts.